Error:
An unexpected error occurred. Please click Reload to try again.
Error:
An unexpected error occurred. Please click Reload to try again.
How to confirm if your SFP transceiver is supported by Palo Alt... - Knowledge Base - Palo Alto Networks

How to confirm if your SFP transceiver is supported by Palo Alto Networks firewall

242325
Created On 03/01/19 17:24 PM - Last Modified 10/11/24 21:27 PM


Objective


To verify if the SFP transceiver currently installed is supported by the firewall

Environment


  • Hardware based firewall
  • SFP transceiver module


Procedure


The currently installed SFP modules can be viewed from the CLI by running the following command: show system state filter sys.sX.pY.phy where X = slot# and Y = port#.

For example, the command for interface 1/21 would be show system state filter sys.s1.p21.phy

A typical SFP module shows the 'vendor-name' and 'vendor-part-number':
> show system state filter sys.s1.p19.phy

sys.s1.p19.phy: { 'link-partner': { }, 'media': SFP-Plus-Fiber, 'sfp': { 'connector': LC, 'encoding': Reserved, 'identifier': SFP, 
'transceiver': 10000B-SR, 'vendor-name': OEM , 'vendor-part-number': PAN-SFP-PLUS-SR , 'vendor-part-rev': B4 , }, 'type': Ethernet, }
'vendor-name': OEM
'vendor-part-number': PAN-SFP-PLUS-SR
 


Additional Information


Support information can be verified against the following document:

Actions
  • Print
  • Copy Link

    https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000boFQCAY&refURL=http%3A%2F%2Fknowledgebase.paloaltonetworks.com%2FKCSArticleDetail

Choose Language