The following CLI commands can be used to view management interface settings.
- show interface management.
- show system state filter cfg.net.s1.eth0.cfg.
Example below:
> show interface management
-------------------------------------------------------------------------------
Name: Management Interface
Link status:
Runtime link speed/duplex/state: unknown/unknown/down
Configured link speed/duplex/state: auto/auto/auto
MAC address:
Port MAC addresss 00:1b:17:eb:4d:fc
Ip address: 192.168.1.120
Netmask: 255.255.255.0
Default gateway: 192.168.1.2
Ipv6 address: unknown
Ipv6 link local address: unknown
Ipv6 default gateway: unknown
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Logical interface counters:
-------------------------------------------------------------------------------
bytes received 0
bytes transmitted 0
packets received 0
packets transmitted 0
receive errors 0
transmit errors 0
receive packets dropped 0
transmit packets dropped 0
multicast packets received 0
--------------------------------------------------------------------------
> show system state filter cfg.net.s1.eth0.cfg
cfg.net.s1.eth0.cfg: { 'fips-gated': True, 'ipaddr': 10.66.19.77, 'ipv6addr': fc00:2:2::77b/96, 'mt
u': 1500, 'netmask': 255.255.254.0, 'onboot': True, 'routes': { 'default': 10.66.18.1, }, 'up': Tru
e, 'v6routes': { 'default': fc00:2:2::1, }, }