How to Perform FIB Lookup for a Particular Destination
Created On 09/25/18 19:25 PM - Last Updated 02/08/19 00:01 AM
This document explains how to perform a fib lookup for a particular destination within a particular virtual router on a Palo Alto Networks firewall.
- Select the desired virtual router from the list of virtual routers configured with the command:
> test routing fib-lookup virtual-router <value>
- Specify a destination IP address:
> test routing fib-lookup virtual-router default ip <ip address>
Note: The output shows the egress interface which will be taken for the destination.
- To display route entries tied to an interface (for example, ethernet1/3), run the following command:
> show routing route | match ethernet1/3